(1) The amount of lubricating grease filling should be appropriate excessive, will increase the friction torque, temperature, increasing the amount of fat consumption; and increase the amount of fat is too little, you can not get reliable lubrication and dry friction occurs . In general, a suitable amount of greasing bearings within the overall void volume of 1/3 ~ 1/2. But according to the specific circumstances, sometimes it should edge greased bearing lubrication effect the cavity.
(2) pay attention to prevent different types, grades and old grease mix to avoid cross-use mounting grease containers and tools. Otherwise, it will produce lipid droplets point depressants, cone penetration increases and the mechanical stability decline adverse effects.
(3) to be replaced with new grease job due greases variety and quality are constantly improving and change, old equipment when switching to a new grease should be by the test, after a trial before the official use; when replacing new grease, you should Clear waste grease, clean the parts. When supplemented with grease, waste greases should be extruded up during the fat mouth to see new grease.
(4) The importance of management in the process of lubrication and greasing before collection, to pay strict attention to the clean containers and tools for grease port on the device should be wiped clean prior prevent mechanical impurities, dust and sand mixed.
(5) Note that season with butter, such as the timely replacement of equipment of their environment and the winter and summer Lee larger temperature changes, if the summer and winter with a fat or vice versa, the result will be counterproductive.
(6) Note that changing grease grease periodically added plus for time should be based on the specific use case may be, it is necessary to ensure reliable lubrication and not cause waste grease.
(7) Do not use a wooden or paper container packaging to prevent loss of oil hardened grease, mixed with water or contaminated deterioration, and should be stored in a cool dry place.
